VtoolShop Blog

TESTING
This menu is used for checking whether key has a working transponder inside or not.
Usage:
Highlight choice 4 using up and down arrows and press enter(right arrow). When there is transponder inside the key “TRANSPONDER” expression will be displayed on Zed-BULL screen, if there is no transponder inside the key only“TEST” expression will be displayed on the screen for some seconds and main menu will be displayed back.

SETTINGS
This menu is used for choosing device language, updating device, getting device info and loading Pc token.
Usage
Highlight choice 5 using up and down arrow and press enter(right arrow), for language selection highlight choice 1 and press enter(right arrow), language options will be displayed on the screen. Highlight your language using up and down arrows and press enter(right arrow) selected language choice is now activated. Use exit button(left arrow) to return back to main menu.
Updating Firmware: When user wants to update device this choice should be selected. The loader version and the serial number is displayed on the screen. Detailed information of firmware update is described in the Pc software settings sub menu.
Loading Pc Token: Load Pc Token sub menu should be choosed in settings menu. In main menu highlight 5th choice(settings) using up and down arrow and press enter(right arrow), highlight choice 4(Load Pc token) and press enter(right arrow).
The device will give an outcode, user should give this outcode to the local distributor, Local distributor will give user an in code. User should enter the in code carefully and correctly. At most 4 times user can enter wrong in code, for the fifth time if wrong incode is entered system will refresh the outcode and realting to this, incode will be refreshed, previous in code will not be used.

If customer transponder data is present, it is possible to type these datas manually using Zed-BULL keypad. This transponder is ready to start the car.

In main menu highlight choice 3 using up and down arrows and press enter(right arrow). Type of transponder will be asked to user. Using up and down arrows choose transponder type that you want to write data. Press enter(right arrow), using key pad type the datas manually and press enter(right arrow). Use up and down arrows to choose the type of transponder that the datas will be written into. Finally press “W” button to write datas to the transponder.

An important point is that the data entered manually, must include valid information for the 11,12,13 and 4C type transponders. Before writing process starts, Zed-BULL checks the validity of the data and informs the user if the data is non-valid.
For example:
ID 11 : should have at least 1 “5F” byte in data string.
ID 12 : should have at least 1 “C1” byte in data string.
ID 13 : should have at least “1111 1111 xxxx xxx1” bit string in data string.
ID 4C : Crc calculation must be valid for the data string.

This menu is used for reading and identifying transponder. Transponder ID, transponder logic, lock status and car type for some models are displayed on the Zed-BULL screen. Also for Renault 33 transponders, pin-code of the car is diplayed.
Usage:
Insert customer key to the Zed-BULL antena and Press “R” button on Zed-BULL keypad or use up and down arrow to highlight choice 1 on main menu and press enter(right arrow).

An important point is; while reading the transponder, It should be put on the antenna perpendicular. See pictures below.

Zed-Bull screen displays of some of identified transponders are as below.